Herramienta computacional modular a partir del modelo dinámico de un aerogenerador de eje horizontal con características mecánicas, eléctricas y electrónicas.
Share
Date
2022-07-26
Authors
Director(s)
Publisher
Universidad Antonio Nariño
Campus
Program
Degree obtained
Document type
COAR type
http://purl.org/coar/resource_type/c_7a1f
Citation
Bibliographic Managers
Document Viewer
Select a file to preview:
item.page.resume
Abstract
Nowadays the power generation from renewable sources, is a national interest topic.
Nevertheless, the wind power generation at a residential level has not beed promoted in our
contry yet, even though regulation of instalation and commercialization for small generators
already exist. Part of the problem, is teaching to the community about this generation
system, which should be support with computational tools taht facilitate understanding of
these technologies. Commercially, there are some software applications that explore these
technologies [1][2][3]. Nevertheless, the software that is in web pages for analysis and teaching
of wind power generation systems usually has a license or is developed for a higher level
than a Mechatronic program. Therefore, a software tool is presented in this TIG, which is
conformed of a graphical interface and a simulation of a horizontal axis generator, which has
beed modeled using computational tools that consider mechanical, electrical and electronic
characteristics.
The paper presents different configurations that an aerogenerator can have. Showing key
information to make the computational tool.
Also the geometric modeling of each piece is included, using Solidworks software, in which
assembly mode was used to couple all pieces in a 3D figure, and so get the physical parameters
of each piece.
With the system parameters the mathematic model of horizontal axis generator was obtained,
using Euler Lagrange equations. Two equations in total were realized to describe the system
and later a block diagram was built in Simulink to validate its behaviour numerically.
After “aerogenerator” system construction in Simulink, the graphical interface was made.
Finally, the tool validation was realized.
item.page.subject.keyword
item.page.coverage.spatial
Colombia(Bogotá D.C)