Diseño y simulación de una maquina dobladora de tubo de 1-½ ´´ para el taller Hierros Gama del Municipio de Palermo.
Loading...
Share
Date
2021-06-04
Authors
Director(s)
Publisher
Universidad Antonio Nariño
Campus
Program
Degree obtained
Document type
COAR type
http://purl.org/coar/resource_type/c_7a1f
Citation
Bibliographic Managers
Document Viewer
Select a file to preview:
item.page.resume
Abstract
One of the problems, which is presented in the ornamentation workshops in the
municipality of Palermo, Huila, is the lack of a tube bending machine to develop and build
structures that require bends, mainly of one and a half inch tubes (1 ½ "), widely used and
demanded in the development of different products, and thus provide higher quality
services to the customer.
In the degree project, the design of a one and a half inch (1 ½ ") tube bending
machine is presented. The historical-logical method is used for the study of the art, the
induction-deduction method for the analysis of the information and the analysis and
synthesis method to determine the key factors of the study.
The design criteria were defined as the size of the machine (height 630 mm, width
550 mm, length 1200 mm), diameter of the bending die (240 mm), contemplating a bending
factor 2.5 and a bending power of 3, 93 Hp.
It was verified by means of simulation that the one and a half inch tube can be
deformed with a load of 123472.06 N, achieving a maximum slope of 3.4 mm at the end of
the tube. The machine design works with a maximum angle of 45° to exert the bend, in two
seconds for the first deformation and is complemented by the use of a five-ton hydraulic
jack to lift 5 mm to adjust the tube.
item.page.subject.keyword
item.page.coverage.spatial
Palermo(Huila, Colombia)